Therapeutic index

Based on efficacy and safety of drugs, there are two types of therapeutic index:

Safety-based therapeutic index

${\displaystyle TI_{\text{safety}}={\frac {LD_{50}}{ED_{50}}}}$ 
It is desirous for the value of LD₅₀ to be as large as possible, to decrease risk of lethal effects and increase the therapeutic window. In the above formula, TI_safety increases as the difference between LD₅₀ and ED₅₀ increases—hence, a higher safety-based therapeutic index indicates a larger therapeutic window, and vice versa.

Efficacy-based therapeutic index

${\displaystyle TI_{\text{efficacy}}={\frac {ED_{50}}{TD_{50}}}}$ 
Ideally the ED₅₀ is as low as possible for faster drug response and larger therapeutic window, whereas a drugs TD₅₀ is ideally as large as possible to decrease risk of toxic effects. In the above equation, the greater the difference between ED₅₀ and TD₅₀, the greater the value of TI_efficacy. Hence, a lower efficacy-based therapeutic index indicates a larger therapeutic window.

Protective index

Similar to safety-based therapeutic index, the protective index uses TD₅₀ (median toxic dose) in place of LD₅₀.

${\displaystyle {\text{Protective index}}={\frac {TD_{50}}{ED_{50}}}={\frac {1}{TI_{\text{efficacy}}}}}$ 

For many substances, toxicity can occur at levels far below lethal effects (that cause death), and thus, if toxicity is properly specified, the protective index is often more informative about a substance's relative safety. Nevertheless, the safety-based therapeutic index (${\displaystyle {TI_{\text{safety}}}}$ ) is still useful as it can be considered an upper bound of the protective index, and the former also has the advantages of objectivity and easier comprehension.

Since the protective index (PI) is calculated as TD₅₀ divided by ED₅₀, it can be mathematically expressed that:

${\displaystyle TI_{\text{efficacy}}={\frac {1}{\text{Protective index}}}}$ 

which means that ${\displaystyle TI_{\text{efficacy}}}$  is a reciprocal of protective index.

All the above types of therapeutic index can be used in both pre-clinical trials and clinical trials.

A low efficacy-based therapeutic index (${\displaystyle TI_{\text{efficacy}}}$ ) and a high safety-based therapeutic index (${\displaystyle TI_{\text{safety}}}$ ) are preferable for a drug to have a favorable efficacy vs safety profile. At the early discovery/development stage, the clinical TI of a drug candidate is unknown. However, understanding the preliminary TI of a drug candidate is of utmost importance as early as possible since TI is an important indicator of the probability of successful development. Recognizing drug candidates with potentially suboptimal TI at the earliest possible stage helps to initiate mitigation or potentially re-deploy resources.

TI is the quantitative relationship between pharmacological efficacy and toxicological safety of a drug, without considering the nature of pharmacological or toxicological endpoints themselves. However, to convert a calculated TI into something useful, the nature and limitations of pharmacological and/or toxicological endpoints must be considered. Depending on the intended clinical indication, the associated unmet medical need and/or the competitive situation, more or less weight can be given to either the safety or efficacy of a drug candidate in order to create a well balanced indication-specific efficacy vs safety profile.

In general, it is the exposure of a given tissue to drug (i.e. drug concentration over time), rather than dose, that drives the pharmacological and toxicological effects. For example, at the same dose there may be marked inter-individual variability in exposure due to polymorphisms in metabolism, DDIs or differences in body weight or environmental factors. These considerations emphasize the importance of using exposure instead of dose to calculate TI. To account for delays between exposure and toxicity, the TI for toxicities that occur after multiple dose administrations should be calculated using the exposure to drug at steady state rather than after administration of a single dose.

A review published by Muller and Milton in Nature Reviews Drug Discovery critically discusses TI determination and interpretation in a translational drug development setting for both small molecules and biotherapeutics.^[2]

The therapeutic index varies widely among substances, even within a related group.

For instance, the opioid painkiller remifentanil is very forgiving, offering a therapeutic index of 33,000:1, while Diazepam, a benzodiazepine sedative-hypnotic and skeletal muscle relaxant, has a less forgiving therapeutic index of 100:1.^[9] Morphine is even less so with a therapeutic index of 70.

Less safe are cocaine (a stimulant and local anaesthetic) and ethanol (colloquially, the "alcohol" in alcoholic beverages, a widely available sedative consumed worldwide): the therapeutic indices for these substances are 15:1 and 10:1, respectively.^[10] Paracetamol, alternatively known by its trade names Tylenol or Panadol, also has a therapeutic index of 10.^[11]

Even less safe are drugs such as digoxin, a cardiac glycoside; its therapeutic index is approximately 2:1.^[12]

Other examples of drugs with a narrow therapeutic range, which may require drug monitoring both to achieve therapeutic levels and to minimize toxicity, include dimercaprol, theophylline, warfarin and lithium carbonate.

Some antibiotics and antifungals require monitoring to balance efficacy with minimizing adverse effects, including: gentamicin, vancomycin, amphotericin B (nicknamed 'amphoterrible' for this very reason), and polymyxin B.

Radiotherapy aims to shrink tumors and kill cancer cells using high energy. The energy arises from x-rays, gamma rays, or charged or heavy particles. The therapeutic ratio in radiotherapy for cancer treatment is determined by the maximum radiation dose for killing cancer cells and the minimum radiation dose causing acute or late morbidity in cells of normal tissues.^[13] Both of these parameters have sigmoidal dose–response curves. Thus, a favorable outcome in dose–response for tumor tissue is greater than that of normal tissue for the same dose, meaning that the treatment is effective on tumors and does not cause serious morbidity to normal tissue. Conversely, overlapping response for two tissues is highly likely to cause serious morbidity to normal tissue and ineffective treatment of tumors. The mechanism of radiation therapy is categorized as direct or indirect radiation. Both direct and indirect radiation induce DNA mutation or chromosomal rearrangement during its repair process. Direct radiation creates a DNA free radical from radiation energy deposition that damages DNA. Indirect radiation occurs from radiolysis of water, creating a free hydroxyl radical, hydronium and electron. The hydroxyl radical transfers its radical to DNA. Or together with hydronium and electron, a free hydroxyl radical can damage the base region of DNA.^[14]

Cancer cells cause an imbalance of signals in the cell cycle. G1 and G2/M arrest were found to be major checkpoints by irradiating human cells. G1 arrest delays the repair mechanism before synthesis of DNA in S phase and mitosis in M phase, suggesting it is a key checkpoint for survival of cells. G2/M arrest occurs when cells need to repair after S phase but before mitotic entry. It is known that S phase is the most resistant to radiation and M phase is the most sensitive to radiation. p53, a tumor suppressor protein that plays a role in G1 and G2/M arrest, enabled the understanding of the cell cycle through radiation. For example, irradiation of myeloid leukemia cells leads to an increase in p53 and a decrease in the level of DNA synthesis. Patients with Ataxia telangiectasia delays have hypersensitivity to radiation due to the delay of accumulation of p53.^[15] In this case, cells are able to replicate without repair of their DNA, becoming prone to incidence of cancer. Most cells are in G1 and S phase. Irradiation at G2 phase showed increased radiosensitivity and thus G1 arrest has been a focus for therapeutic treatment. Irradiation of a tissue induces a response in both irradiated and non-irridiated cells. It was found that even cells up to 50–75 cell diameters distant from irradiated cells exhibit a phenotype of enhanced genetic instability such as micronucleation.^[16] This suggests an effect on cell-to-cell communication such as paracrine and juxtacrine signaling. Normal cells do not lose their DNA repair mechanism whereas cancer cells often lose it during radiotherapy. However, the high energy radiation can override the ability of damaged normal cells to repair, leading to additional risk of carcinogenesis. This suggests a significant risk associated with radiation therapy. Thus, it is desirable to improve the therapeutic ratio during radiotherapy. Employing IG-IMRT, protons and heavy ions are likely to minimize the dose to normal tissues by altered fractionation. Molecular targeting of the DNA repair pathway can lead to radiosensitization or radioprotection. Examples are direct and indirect inhibitors on DNA double-strand breaks. Direct inhibitors target proteins (PARP family) and kinases (ATM, DNA-PKCs) that are involved in DNA repair. Indirect inhibitors target protein tumor cell signaling proteins such as EGFR and insulin growth factor.^[13]

The effective therapeutic index can be affected by targeting, in which the therapeutic agent is concentrated in its desirable area of effect. For example, in radiation therapy for cancerous tumors, shaping the radiation beam precisely to the profile of a tumor in the "beam's eye view" can increase the delivered dose without increasing toxic effects, though such shaping might not change the therapeutic index. Similarly, chemotherapy or radiotherapy with infused or injected agents can be made more efficacious by attaching the agent to an oncophilic substance, as in peptide receptor radionuclide therapy for neuroendocrine tumors and in chemoembolization or radioactive microspheres therapy for liver tumors and metastases. This concentrates the agent in the targeted tissues and lowers its concentration in others, increasing efficacy and lowering toxicity.

Sometimes the term safety ratio is used, particularly when referring to psychoactive drugs used for non-therapeutic purposes, e.g. recreational use.^[10] In such cases, the effective dose is the amount and frequency that produces the desired effect, which can vary, and can be greater or less than the therapeutically effective dose.

The Certain Safety Factor, also referred to as the Margin of Safety (MOS), is the ratio of the lethal dose to 1% of population to the effective dose to 99% of the population (LD₁/ED₉₉).^[17] This is a better safety index than the LD₅₀ for materials that have both desirable and undesirable effects, because it factors in the ends of the spectrum where doses may be necessary to produce a response in one person but can, at the same dose, be lethal in another.

${\displaystyle {\text{Certain safety factor}}=\mathrm {\frac {LD_{1}}{ED_{99}}} }$ 

A therapeutic index does not consider drug interactions or synergistic effects. For example, the risk associated with benzodiazepines increases significantly when taken with alcohol, opiates, or stimulants when compared with being taken alone.^{[medical citation needed]} Therapeutic index also does not take into account the ease or difficulty of reaching a toxic or lethal dose. This is more of a consideration for recreational drug users, as the purity can be highly variable.

The therapeutic window (or pharmaceutical window) of a drug is the range of drug dosages which can treat disease effectively without having toxic effects.^[18] Medication with a small therapeutic window must be administered with care and control, frequently measuring blood concentration of the drug, to avoid harm. Medications with narrow therapeutic windows include theophylline, digoxin, lithium, and warfarin.

Optimal biological dose (OBD) is the quantity of a drug that will most effectively produce the desired effect while remaining in the range of acceptable toxicity.

The maximum tolerated dose (MTD) refers to the highest dose of a radiological or pharmacological treatment that will produce the desired effect without unacceptable toxicity.^[19][20] The purpose of administering MTD is to determine whether long-term exposure to a chemical might lead to unacceptable adverse health effects in a population, when the level of exposure is not sufficient to cause premature mortality due to short-term toxic effects. The maximum dose is used, rather than a lower dose, to reduce the number of test subjects (and, among other things, the cost of testing), to detect an effect that might occur only rarely. This type of analysis is also used in establishing chemical residue tolerances in foods. Maximum tolerated dose studies are also done in clinical trials.

MTD is an essential aspect of a drug's profile. All modern healthcare systems dictate a maximum safe dose for each drug, and generally have numerous safeguards (e.g. insurance quantity limits and government-enforced maximum quantity/time-frame limits) to prevent the prescription and dispensing of quantities exceeding the highest dosage which has been demonstrated to be safe for members of the general patient population.

Patients are often unable to tolerate the theoretical MTD of a drug due to the occurrence of side-effects which are not innately a manifestation of toxicity (not considered to severely threaten a patient's health) but cause the patient sufficient distress and/or discomfort to result in non-compliance with treatment. Such examples include emotional "blunting" with antidepressants, pruritus with opiates, and blurred vision with anticholinergics.

• Drug titration – process of finding the correct dose of a drug
• Effective dose
• EC50
• IC50
• LD50
• Hormesis